在升降舞臺http://m.s8309.cn/中，載荷傳感器最重要的一點是傳感器軸承座必須與卷筒軸保持同心度，以保證傳感器的安裝精度，安裝時不能猛擊、捶打傳感器部位。
In the landing stage, the most important point load cell sensor bearing must remain concentric with the spool shaft, in order to ensure accuracy of the sensor installation, the installation can not hit, beat sensor site.

升降舞臺所有緊固螺釘必須擰緊，露天使用應加防雨罩，控制顯示儀表安裝，可懸掛在離司機盡量近的位置，以便于司機觀察和操作，安裝要穩固、最好采用一定的防振措施。
Landing stage all fastening screws must be tightened Covers outdoor use should be added to control display instrument installation, it can be hung from the driver in a position as close as possible in order to observe and operate the driver, installed to secure the best use of certain anti-vibration measures.

從升降舞臺http://m.s8309.cn/傳感器至顯示控制儀表的信號電纜，可以用4芯屏蔽電纜，也可以用普通的橡膠護套控制軟電纜，但不管使用哪種電纜，芯線截面不得小于1.5mm，中間不得有接頭，但可以使用接線盒內采用有防松措施的接線端子。
From the landing stage sensor to the display control of the signal cable, you can use 4-conductor shielded cable, you can use an ordinary rubber sheathed flexible control cable, but no matter what kind of cable, wire cross section of not less than 1.5mm, the middle may not have joints , but you can use the terminal box use have against rotation terminals.